Treatex^® Water-based Lacquer FAQs

What can I do if the lacquer does not dry in the specified time?

This could be due to either the room temperature being too low or the air humidity being too high. Increase the temperature to 20ºC to allow the surface to dry properly.

What can I do if the surface has not become smooth?

This could be the result of not removing sanding dust from the surface before application. Sand down the surface and reapply the lacquer. Be careful to remove all dust and dirt before application!

What can I do to prevent trapped air on the surface?

Trapped air is caused by using the wrong tools for application. Sand down the floor and reapply the lacquer using a Treatex^® Roller.

What can be done in case of mechanical impression or damage of the surface, due to using the floor too soon?

In this case, the floor has not been allowed to harden sufficiently. Sand down the floor and apply Treatex® Floor Lacquer Water-based again. Pay attention to temperature and humidity!

What can I do to prevent spotting?

Spotting is caused by not completely removing excess floor filler. We recommend sanding down the floor and reapplying lacquer.