Cart 0
Cart 0

Features

  • Low Odour

  • Meets with VOC emissions regulations

  • Easy to apply

  • Quick drying

Protected with same features of Treatex Hardwax Oil Clear when 2 coats are applied (see: Treatex Hardwax Oil Ultra Clear).

 

Coverage

0.5L will cover approximately 10m² in one coat depending on the timber and method of application.
1L will cover approximately 20m² in one coat depending on the timber and method of application.
2.5L will cover approximately 50m² in one coat depending on the timber and method of application.

Please note! 
Clear Hardwax Oil must always be used as the final coat when Natural Hardwax Oil or Colour Tones are applied*

*Natural can be used as a top coat with Spruce Colour Tone to achieve a pure bright white (see: Hardwax Oil Natural).

Compatibility

Treatex Hardwax Oil Clear / Treatex Hardwax Oil Natural (used over Spruce Colour Tone Early)

Preparation

Sand the surface to smooth bare wood using 80-120 grit sandpaper. Ensure that any previous finish has been fully removed. Remove dust, dirt and any other contaminates which may lead to uneven absorption of Colour Tones. Make sure the surface to be treated is thoroughly dry. Stir tins and ensure product is at room temperature before use. Enough Colour Tone should be purchased to complete the whole project and when more than one container is required it is advisable to mix them together before use. Various species of timbers will take colours differently, we strongly advise a small trial application prior to starting a project.

Application

One coat of Colour Tone should brushed or rolled on. A second coat of Colour Tone is usually unnecessary and will deepen the colour. To ensure an even colour, remove excess product from the surface with a lint free cloth. Allow to dry - maintaining warmth and ventilation will enable the surface to dry within 3-6 hours. If excess product is not removed from the surface, Colour Tones will not dry properly and may appear patchy. Once dry, seal with two coats of Treatex Hardwax Oil Ultra Clear which is available in Flat Matt, Matt, Satin or Gloss sheen levels. The top coats of Clear Hardwax Oil are applied to prevent the natural pigments in our Colour Tones from wearing. 

Tips

All of our Colour Tones can be mixed. Treatex brushes and rollers are available. Alternatively, use a short gloss pile roller or good quality brush. Wet brushes and rollers can be cleaned using white spirit. To speed up drying, raise room temperature and increase air flow by opening doors, windows and using a fan. For a brighter white seal our Spruce Colour Tone with two coats of Treatex Hardwax Oil Ultra Natural instead of Clear Hardwax Oil (see: Treatex Hardwax Oil Natural).