Item No. 500 (Cool Cotton), 501 (Bleached Wood,) 502 (Sea Mist), 503 (Old Pewter), 504 (Battleship Grey), 505 (Is This Pink?), 506 (Burgundy Red), 507 (Fresh Lemon), 508 (Sage Green), 509 (Forest Green), 510 (Granny's Bonnet), 511 (Midnight Blue), 512 (Stygian), 513 (Ash Bark Green), 514 (Saddle Brown), 515 (Heather Haze), 516 (Admiralty Grey), 517 (Black), 518 (Terracotta), 519 (Muntjac), 520 (Symphony Blue)
Sizes: 0.5 Litre, 1 Litre
- Easy to apply
- High coverage
- UV resitant
- Will not flake or peel
- Contains no biocides or preservatives
- Highly water resistant
Suitable for: internal and external use
Recommended timbers: All
Applications: doors, windows, fences, sheds, cladding and kitchen cabinets
0.5L covers approximately 12.5m² in one coat or 7.5m² in two coats depending on the timber and method of application.
1L covers approximately 25m² in one coat depending on the timber and method of application.
Treatex Classic Colour Collection is available in the following colours:
Colours shown are indicative and are only as accurate as web displays allow.
Click the images below for full size and what colours have been used.
Treatex Classic Colour Collection works best on unfinished timber. Previous porous finishes should be thoroughly cleaned or lightly sanded before overcoating. Flaking or peeling finishes must be fully removed prior to application. A trial application is essential when overcoating another finish. Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust etc. Exterior timbers susceptible to decay, mould and fungi should be treated first with Treatex Preservative. To help prevent staining, exterior timbers with high tannin levels (e.g. oak, idigbo, teak, cedar, mahogany) should be treated with Treatex Stain Inhibitor. We advise that when using Treatex Classic Colour Collection, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use. Timber must have a moisture content below 18%. Temperature must be greater than 8°𝖼 during application and drying. We strongly recommend a trial application prior to starting the project.
Stir tins thoroughly, before and during use. Use a brush or roller to evenly apply Treatex Classic Colour Collection in the same direction as the wood grain, allowing approximately 40ml
per m². If possible, apply the first coat to all sides of the wood before installation. Pay particular attention to any end grain. To ensure the timber is fully sealed apply the product liberally on end grain. After approximately 12 hours drying the first coat can be overcoated. Apply with a brush or roller a second coat of Treatex Classic Colour Collection, again allowing roughly 40ml per m². After the second coat, leave for approximately 12-24 hours to dry. A third coat may be needed if applying a light colour on a dark timber. One coat may be enough when renovating previously porous finishes.
Treatex brushes and rollers are available. Wet brushes and rollers can be cleaned with Treatex Thinner or white spirit. Store tins in a cool and frost free environment. Unopened tins will last for five years. Once tins are opened, transfer contents to smaller airtight container. For a different sheen level on internal timbers Treatex Classic Colour Collection can be overcoated with Treatex Hardwax Oil Clear Matt, Satin or Gloss.